User's Manual

Lucent Technologies — Proprietary
See notice on first page
401-660-100 Issue 11 August 2000
20-3
AMapping Status Display Page Unit Numbers to
Hardware
Although the DFI has two physical facility ports, only a single facility port is
currently supported.
The mappings in Figure 20-1 shows how the CAT logical unit numbers on the
status display pages map to their physical counterparts in a partially and fully
equipped, non-CDMA, Series II Cell Site. The range for CAT logical numbers in a
non-CDMA Cell Site is 0 through 3. The active (on-line) CAT, CAT 0 or CAT 1 (See
Figure 20-3), provides the TDM bus clocks for TDM0. The active CAT, CAT 2 or
CAT 3, provides the TDM bus clocks for TDM1.
NOTE:
T
DM buses are always installed "red stripe up."