User's Manual

Lucent Technologies — Proprietary
See notice on first page
401-660-100 Issue 11 August 2000
16-15
Corrective Maintenance using Status Display Pages
After the system processes the command, an output message report scrolls up
from the bottom of the window. In addition, the output message report is sent to a
log file. The following is an example of a successful output message report.
Example:
OP:CELL 1 CSC 0, OOS, MANUAL, DGN
References:
See the following documents for additional information:
■
AUTOPLEX Cellular Telecommunications Systems System 1000 Output
Messages (401-610-057)
2132 - Cell
Software Status
Display Page
The
2132 - Cell Software Status
page (See Figure 16-3) provides software
status indicators and allow/inhibit page commands for the following Cell Site
software processes:
■
Audits
■
Audit/HEH (hardware error handler) output
■
Boot (initialization)
■
Call processing
■
Forward setup channel control
■
Routine functional tests
■
Interrupts
■
Phase monitoring
■
Routine diagnostics
■
Diversity error imbalance output.
2132 - Allowing/Inhibiting Cell Software Processes
You can use the
2132 - Cell Software Status
page to allow/inhibit the following
Cell Site software processes (See Figure 16-3):
■
Audits
■
Audit/HEH (hardware error handler) output
■
Boot (initialization)
■
Call processing
■
Forward setup channel control
■
Routine functional tests