User's Manual

Lucent Technologies — Proprietary
See notice on first page
16-18
401-660-100 Issue 11 August 2000
Corrective Maintenance using Status Display Pages
NOTE:
This ends the procedure for using the
2132
page to allow/inhibit various
Cell Site software processes.
Result
:
After the system processes the command, an output message report scrolls up
from the bottom of the window. In addition, the output message report is sent to a
log file. The following is an example of a successful output message report.
Example:
INH:CELL 1 RTDIAG COMPLETED
References:
See the following documents for additional information:
■
AUTOPLEX Cellular Telecommunications Systems System 1000 Output
Messages (401-610-057)
2133 - Cell Voice
Radio (VR) Status
Display Page
The
2133 - Series II Cell VR Status
page (See Figure 16-4, and Table 16-5)
displays the summary state of each voice radio (See Table 16-6) at a specified
Cell Site. This page also displays the number of the DCS serving the Cell Site,
and the Cell Site trunk groups associated with each of the logical antenna faces.
Each logical antenna face is identified by server group (SG) and physical antenna
face (ANT).
This display page applies to AMPS and TDMA but not CDMA.
In addition, this page has maintenance commands to:
■
Conditionally or unconditionally remove and restore radios
■
Diagnose radios
■
Conditionally or unconditionally remove server group antennas
■
Conditionally restore server group antennas
■
Diagnose server group antennas
■
Generate server group antenna status message output reports.
An AMPS radio (RCU or SBRCU) having a voice radio personality may also have
a beacon radio personality. Thus, an RCU or SBRCU can serve two functions
concurrently: (1) carry an over-the-air AMPS call and (2) provide signal strength
measurements for the TDMA mobile-assisted handoff (MAHO) procedure. Since