User's Manual

Lucent Technologies — Proprietary
See notice on first page
401-660-100 Issue 11 August 2000
16-47
Corrective Maintenance using Status Display Pages
2. Open the
2139 - Cell CCC CCU Status
page by entering command
2139,
c
,
n (where c is the Cell Site number and n is the CDMA cluster
controller number).
3. At the
CMD<
line,
To. . .
enter...
Conditionally remove a CCU
200,
followed by the CCU number (1-7) and
press
RETURN
.
For example:
200,1
and a
RETURN
conditionally removes CCU 1.
Unconditionally remove a CCU
201,
followed by the CCU number (1-7) and
press
RETURN
.
Conditionally restore a CCU
300,
followed by the CCU number (1-7) and
press
RETURN
.unconditionally restore a
CCU
301,
followed by the CCU number (1-7)
and press
RETURN
.
Generate a status message
output report for a CCU
400,
followed by the CCU number (1-7) and
press
RETURN
.
Diagnose a CCU
500,
followed by the CCU number (1-7) and
press
RETURN
(provided that doing so does not
violate maintenance action rules; for example,
units are out-of-service or not in the active state).
NOTE:
This ends the procedure for using the
2139
page to remove, restore,
diagnose, or generate a status output message report for a CCU.
Result:
After the system processes the command, an output message report scrolls up
from the bottom of the window. In addition, the output message report is sent to a
log file. The following is an example of a successful output message report.
Example:
DGN:CELL 8 CCC 7, CCU 1 COMPLETED ALL TESTS PASSED