User's Manual

Lucent Technologies — Proprietary
See notice on first page
17-4
401-660-100 Issue 11 August 2000
Corrective Maintenance using ECP Craft Interface
c. Indicates message class override.
RUNVM
Generates the status on all radio units currently
undergoing NVM updating.
NOTE:
See the AUTOPLEX Cellular Telecommunications Systems System 1000
Input Messages (401-610-055) for more information about message
parameters.
Result
:
After the system processes the command, an output message report scrolls up
from the bottom of the window. In addition, the output message report is sent to a
log file. The following is an example of a successful output message report.
Example:
OP:CELL 1 SU 7, ACTIVE, FORCED
References
:
See the following documents for additional information:
■
AUTOPLEX Cellular Telecommunications Systems System 1000 Output
Messages (401-610-057)
■
AUTOPLEX Cellular Telecommunications Systems System 1000 User
Defined Cell Site Alarms (401-612-057)
■
AUTOPLEX System 1000 Virtual System Output Message Routing
Optional Feature (401-612-021)
NOTE:
Feature documents are contained in AUTOPLEX Cellular
Telecommunications Systems System 1000 Optional Features (401-900-
004)
■
AUTOPLEX Cellular Telecommunications Systems System 1000 Series II
Cell Site Description, Operation, and Maintenance (401-660-100).
Removing Cell
Site Units
You can remove specific Cell Site units from service, all busy voice radios with a
specified camp-on time, or all radios with a non-volatile memory (NVM) that is
incompatible with the Cell Site controller (CSC).
The conditional remove maintenance action changes the state of a maintenance
unit from active or standby to out-of-service. It schedules an event or process to