User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

xxv

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

PERFORM THE NEXT TWO STEPS ONLY IF INSTALLING A PRIMARY CABINET

Move/lift the primary cabinet into position 2 - 31

Install anchoring bolts or anchor assemblies and level the primary cabinet 2 - 32

PERFORM THE NEXT SEVEN STEPS ONLY IF INSTALLING A WNG24-BC BATTERY CABINET

Prepare the existing cabinet for attachment of an additional cabinet 2 - 35

Prepare the cabinet being installed for attachment to the existing cabinet 2 - 37

Partially install the AC cable guide in the cabinet being installed 2 - 39

Move/lift the cabinet being installed into position 2 - 40

Attach the cabinets together at the square cable support (with second battery

cabinet only)

2 - 42

Install anchoring bolts or anchor assemblies and level the battery cabinet(s) 2 - 45

Complete the installation of the AC feed-through coupling and tighten the

anchor bolts or nuts

2 - 48

PERFORM THE NEXT SEVEN STEPS ONLY IF INSTALLING A 4.0B DUAL BAND CABINET

Prepare the previous Modular Cell cabinet for connection of a 4.0B dual band

cabinet

2 - 51

Partially install the AC cable guide in the previous Modular Cell cabinet, if

applicable

2 - 53

Prepare the 4.0B dual band cabinet for connection to the previous Modular Cell

cabinet

2 - 54

Position the 4.0B dual band Modular Cell cabinet 2 - 56

Install anchoring bolts or anchor assemblies and level the 4.0B dual band

cabinet

2 - 58

Finish the installation of the AC cable guide and tighten the anchor bolts 2 - 60

Attach the 4.0B dual band Modular Cell cabinet to the previous Modular Cell

cabinet at the RF cable guide

2 - 62

PERFORM THE NEXT FIVE STEPS FOR ALL CABINETS, IF APPLICABLE

Install the cabinet grounding cables 2 - 65

Remove the lifting eye bolts 2 - 67

Install the top solar shield 2 - 70

Install the right side solar shield on the primary cabinet (reference, if applicable) 2 - 75

Adjust the door roller bearing (if required) 2 - 76

COMPLETED INSTALLATION STEP PAGE