User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

xxvi

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Chapter 3: Cable connections in the Modular Cell 4.0B cabinets

Overview

Table 2 lists the procedures covered in Chapter 3 for cable connections

in the 4.0B Modular Cell primary and dual band cabinets.

Modular Cell 4.0B Primary Cabinet Serial Number:

_______________________________

Modular Cell 4.0B Dual Band Cabinet Serial Number:

_______________________________

Table 2

Chapter 3

COMPLETED INSTALLATION STEP PAGE

PERFORM THE NEXT THREE STEPS IF INSTALLING A 4.0B PRIMARY CABINET, IF APPLICABLE

Connect the unterminated end of the GPS jumper cables to the Modular Cell

4.0B primary cabinet, if applicable

3 - 4

Connect a terminated end of the GPS antenna jumper cables to the Modular

Cell 4.0B primary cabinet, if applicable

3 - 8

Connect the GPS antenna jumper cable to the GPS surge protector at the GPS

antenna cable

3 - 11

PERFORM THE NEXT STEP TO INSTALL THE CONDUITS FOR TI/E! LINES AND EXTERNAL USER ALARMS

Connect the conduit between the metal conduits and the antenna cable cover

of the 4.0B primary cabinet

3 - 13

PERFORM THE NEXT STEP IF INSTALLING A DUAL BAND CABINET IN AN INTEGRATED POWER LINE-UP

Route T1/E1 cables to the Modular Cell 4.0B dual band cabinet 3 - 16

PERFORM THE NEXT STEP IF INSTALLING A DUAL BAND CABINET IN A LINE-UP WITH A POWERHOUSE 24 CABINET

Route the T1/E1 cable(s) to the Modular Cell 4.0B dual band cabinet (in line-

ups that utilize existing PowerHouse24 or customer supplied power)

3 - 19

PERFORM THE NEXT STEP IF INSTALLING A DUAL BAND CABINET IN A LINE-UP WITH A WNG POWER CABINET

Route the T1/E1 cable(s) to the Modular Cell 4.0B dual band cabinet (in

installations that utilize an existing WNG power cabinet)

3 - 24

PERFORM THE NEXT TWO STEPS IF INSTALLING T1/E1 AND/OR USER ALARM CABLES

Install the EMI / RFI cord grip seals with T1/E1 and user alarm cables 3 - 29

Prepare the T1/E1 and user alarm cables for punchdown and ground

connection at the facilities interface module

3 - 33