User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

xxxiv

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Chapter 7: Finishing the installation

Overview

Table 6 lists the procedures covered in Chapter 7 for finishing the

installation of the Modular Cell 4.0B primary cabinet and dual band

cabinets, as well as the WNG24-BC battery cabinets.

Modular Cell 4.0B Primary Cabinet Serial Number:

_______________________________

Modular Cell 4.0B Dual Band Cabinet Serial Number:

_______________________________

WNG24-BC Battery Cabinet Serial Number:

_______________________________

Table 6

Chapter 7

COMPLETED INSTALLATION STEP PAGE

PERFORM THE NEXT THREE STEPS TO VERIFY ANTENNA STATUS AND REFERENCE POWER UP AND SYSTEM TESTS

Verify GPS antenna connection 7 - 3

Verify RF antennas not connected 7 - 3

Perform power-up and system test 7 - 4

PERFORM THE NEXT FIVE STEPS IF INSTALLING A 4.0B PRIMARY OR DUAL BAND CABINET

Test and connect the internal battery cables (if applicable) 7 - 5

Connect the unterminated end of the RF antenna jumper cables to the Modular

Cell 4.0B primary or 4.0B dual band cabinet

7 - 8

Connect a terminated end of the outdoor RF antenna jumper cables to the

Modular Cell 4.0B primary or 4.0B dual band cabinet

7 - 12

Connect RF antenna jumper cables to the antenna cables 7 - 15

Replace / close all access panels and doors 7 - 18

PERFORM THE NEXT STEP IF INSTALLING A FIRST OR SECOND BATTERY CABINET

Finish the installation of the first or second WNG24-BC battery cabinet 7 - 19