User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Installation process

Appendix B: Non-Lucent power ancillary hardware installation, cable

routing and connection

Overview

Table 8 lists the procedures covered in Appendix B for Non-Lucent

power ancillary hardware installation, cable routing and connection to

Modular Cell 4.0B primary and dual band cabinets.

Modular Cell 4.0B Primary Cabinet Serial Number:

_______________________________

Modular Cell 4.0B Dual Band Cabinet Serial Number:

_______________________________

Table 8

Appendix B

COMPLETED INSTALLATION STEP PAGE

PERFORM THE NEXT FOUR STEPS TO INSTALL THE ANCILLIARY HARDWARE AND PHYSICALLY ATTACH THE NON LUCENT

POWER SOURCE

Install the cable duct assembly B - 4

Install the AC conduit B - 6

Attach the non-Lucent power source directly to the cable duct (zero spacing), if

applicable

B - 11

Attach the non-Lucent power source to the cable duct assembly using conduits. B - 14

PERFORM THE NEXT TWO STEPS TO ROUTE AND CONNECT THE DC CABLES BETWEEN THE NON-LUCENT POWER SOURCE

AND THE MODULAR CELL 4.0B PRIMARY CABINET

Route the DC cables from the Modular Cell 4.0B primary cabinet to the non-

Lucent power source

B - 22

Connect the DC cables at the Modular Cell 4.0B primary cabinet B - 24

PERFORM THE NEXT FOUR STEPS TO ROUTE AND CONNECT THE POWER ALARM CABLE BETWEEN THE NON-LUCENT POWER

SOURCE AND THE MODULAR CELL 4.0B PRIMARY CABINET

Route the power source alarm cable to the Modular Cell 4.0B primary cabinet B - 27

Install the EMI / RFI cord grip seal with the alarm cable B - 32

Prepare the alarm cable for punchdown and ground connection at the facilities

interface panel

B - 35

Connect alarm cable to the EFIM punchdowns in Modular Cell 4.0B cabinet B - 37

PERFORM THE NEXT THREE STEPS TO ROUTE AND CONNECT THE AC CABLE(S) BETWEEN THE NON-LUCENT POWER

SOURCE AND THE MODULAR CELL 4.0B PRIMARY CABINET

Route the AC power cables to the Modular Cell 4.0B primary cabinet B - 42