User's Manual

Installation process
xli
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Connect the AC power cable for the heaters in the primary cabinet B - 46
Connect the AC power cable for the convenience outlet in the primary cabinet
(NAR only)
B - 48
PERFORM THE NEXT FOUR STEPS TO ROUTE AND CONNECT THE DC CABLES BETWEEN THE NON-LUCENT POWER SOURCE
AND THE MODULAR CELL DUAL BAND CABINET
Install the 2-1/2-inch chase nipple if the power source is connected directly to
the cable duct
B - 52
Install a 2-1/2-inch conduit if the power source is not connected directly to the
cable duct
B - 53
Route the DC cables from the dual band cabinet to the non-Lucent power
source
B - 59
Connect the DC cables at Modular Cell 4.0B dual band cabinet B - 62
PERFORM THE NEXT TWO STEPS TO ROUTE AND CONNECT THE AC CABLE(S) BETWEEN THE NON-LUCENT POWER SOURCE
AND THE MODULAR CELL 4.0B DUAL BAND CABINET
Route and connect the WH103 AC cable for the heater from the primary to the
dual band cabinet
B - 66
Route and connect the WH104 AC cable for the convenience outlet, from the
primary to the dual band cabinet (NAR cabinets only)
B - 70
COMPLETED INSTALLATION STEP PAGE