User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

4-2

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Power and power alarm connections in Modular Cell 4.0B

cabinets with integrated power

Modular Cell 4.0B cabinets without

integrated power that utilize non-

Lucent power (reference)

Overview

Objectives

To provide non-Lucent customer supplied power connection references

Non-Lucent power references

References

Important! If installing a Modular Cell 4.0B cabinet with

integrated power, proceed to Power and alarm wiring overview on

Page 4 - 3. If installing a Modular Cell 4.0B cabinet without

integrated power, that utilizes non-Lucent customer supplied

power, proceed as below:

For DC power and power system alarm requirements, refer to

Appendix B of the following document.

• Flexent Modular Cell 4.0/4.0B Outdoor Site Preparation

Guidelines, 401-703-413

If the requirements listed in the applicable document have been met,

refer to the applicable vendor documentation, and skip to the following

appendix to continue the installation:

Appendix B of this document for installation the ancillary hardware,

and the routing and connection of DC, AC and alarm cables from a

non-Lucent power source to an outdoor Modular Cell 4.0B cabinet.

After completion of Appendix B, return to:

• Chapter 6 if installing a 4.0B dual band cabinet

• Chapter 7 to finish the installation.