User's Manual

2-64
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
................................................................................................................................
............................................
2 Refer to the figure below and tighten the RF cable guide screws using
the tightening sequence shown.
1
2
3
4
5
6
7
8
NOTE:
For 1.0, 2.0, and 3.0 existing
cabinets screws 1 through 8
are threaded into loose nuts
inside the existing cabinet.
For 4.0 and 4.0B existing cab-
inets screws 1 through 8 are
threaded into permanent nuts
attached inside the existing
cabinet.
FRONT
DUAL BAND CABINET-
INSIDE VIEW