User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 67
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Remove the lifting eye
bolts
Use the following procedure to remove the lifting eye bolts.
Important! Modular Cell cabinets require a top solar shield. If
installing Modular Cell primary or dual band cabinets, perform
only Step 1 and then skip to Solar shield table on Page 2 - 69 to
continue the installation.
................................................................................................................................
............................................
1 Remove the lifting eye bolts (if installed).
Important! Perform the next steps only for battery cabinets
(which do not require a top solar shield).
WARNING
................................................................................................................................
.............................................
Equipment damage
If performing the next three steps, the nut must be held in
position while the replacement bolt is tightened. Otherwise,
the nut can become loose and result in water leakage into the
cabinet.
2 Thread one of the stainless steel bolts (provided with the cabinet) in
place of the removed lifting eye bolt.
................................................................................................................................
............................................
3 Hold the nut on the top of the cabinet with a 1-1/8 inch (29 mm) wrench.
Refer to the figure on Page 2-68.