User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 71
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
2 Thread the four stand-offs (“insulating spacers”, Item 3 on Page 2 - 73)
into the mounting hole locations and tighten to 50 in.-lb. (5.6 Nm).
................................................................................................................................
............................................
3 Place the solar shield assembly (Items 1 and 2 on Page 2 - 73) on top of
the four stand-offs installed in the previous step, with the five slotted
screw heads facing up and the five nuts down. Refer to the figure on
Page 2-74.
................................................................................................................................
............................................
4 Align the open slots of the solar shield assembly over the stand-offs as
shown in the figure below.
MODULAR CELL 4.0B CABINET
TOP VIEW
FRONT
REAR
ANTENNA
CABLE
COVER
MOUNTING HOLE
LOCATIONS
MOUNTING HOLE
LOCATIONS
OPEN SLOTS IN SOLAR SHIELD
ASSEMBLY (ONE OF FOUR TOP
AND BOTTOM SETS)
THREADED HOLE
IN STAND-OFF
STAND-OFF
FRONT