User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

2-76

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Modular Cell 4.0B and WNG24-BC cabinet handling,

placement, anchoring and grounding

Door adjustment procedure

Adjust the door roller

bearing (if required)

Perform the following steps to adjust the door roller bearing.

................................................................................................................................

............................................

1 Check the top of the door with the door closed. The top surface of the

door should be flush with the top surface of the cabinet +/- 1 mm (.039

inch) when the door is closed. If the door is too low, skip to Step 6. If

the door is too high, continue from Step 1.

................................................................................................................................

............................................

2 Turn the height adjustment screw three turns counter-clockwise. Refer

to the figure below.

................................................................................................................................

............................................

3 Loosen the six clamping screws by one full turn each. Refer to the figure

below.

................................................................................................................................

............................................

4 Move the roller upward until the bracket comes into contact with the

height adjustment screw, and then tighten the six clamping screws.