User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 77
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
5 Close and check the top of the door. If the door is still too high, so the
roller needs to be lifted higher, repeat the previous steps, but turn the
height adjustment screw counter-clockwise one turn at a time. If the
door is now too low, proceed to the next step, but turn the height
adjustment screw only one turn at a time.
................................................................................................................................
............................................
6 Loosen the six clamping screws by one full turn each.
................................................................................................................................
............................................
7 Turn the height adjustment screw three turns clockwise.
................................................................................................................................
............................................
8 Tighten the six clamping screws.
................................................................................................................................
............................................
9 Close and check the top of the door. If the door is still too low, so the
roller needs to be lowered further, repeat the previous steps, but turn the
height adjustment screw clockwise one turn at a time. If the door is now
too high, return to Step 2, but turn the height adjustment screw only one
E ND OF STEPS
................................................................................................................................
.............................................
turn at a time.