User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

3- 1

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

3 Cable connections in the

Modular Cell 4.0B cabinets

Overview

Purpose

This chapter provides instructions for routing and connecting the GPS

antenna, T1/E1, and user alarm cables required for installing the

Modular Cell 4.0B primary cabinet (and T1/E1 only for dual band

cabinets). See Chapter 4 for AC power connections and WNG battery

cabinet installation. See Appendix A for EZBFo battery frame

installation. See Appendix B for Non-Lucent power and power alarm

connections. The T1/E1 installation will vary depending upon the

Universal Radio Controller (URC or URCII) in use.

Cable connection references 3 - 2

Installation of the GPS antenna jumper cable for the 4.0B primary cabinet 3 - 3

Connection of the conduit with T1/E1 lines and external user alarms cables to a 4.0B

primary cabinet

3 - 13

How to route the T1/E1 cable(s) to a Modular Cell 4.0B dual band cabinet in a line-up that

has a Modular Cell 3.0, 4.0, or 4.0B primary cabinet with integrated power

3 - 16

How to route the T1/E1 cable(s) to a Modular Cell 4.0B dual band cabinet in a line-up that

has a Modular Cell 1.0, 2.0, 3.0, 4.0, or 4.0B primary cabinet without integrated power

3 - 18

Routing of T1/E1 and user alarm cables into a Modular Cell 4.0B cabinet 3 - 27

Connection of T1/E1 Lines to the EFIM punchdowns in Modular Cell 4.0B cabinets 3 - 35

Connection of user alarms to the EFIM punchdown blocks in the Modular Cell 4.0B primary

cabinet

3 - 48