User's Manual

3-4
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Cable connections in the Modular Cell 4.0B cabinets
Connect the unterminated
end of the GPS jumper
cables to the Modular Cell
4.0B primary cabinet, if
applicable
Important! If both ends of the GPS jumper cable are
terminated, skip to Connect a terminated end of the GPS antenna
jumper cables to the Modular Cell 4.0B primary cabinet, if applicable on
Page 3 - 8 to continue the installation.
If the GPS antenna jumper cable is terminated on only one end, the
unterminated end will be terminated and attached to the GPS connector
on the Modular Cell 4.0B cabinet. Use the following procedure to
connect the GPS antenna jumper cable to the Modular Cell 4.0B
primary cabinet.
................................................................................................................................
............................................
1 Cut the unterminated end of the cable to the correct length. Allow
adequate slack for a drip loop and cut the cable to the correct length.
Refer to the figure on Page 3-11
Important! When performing the next step, do not prepare the
unterminated end of the cable for the subsequent attachment of the
connector. The sharp edges that would result will damage the
rubber boot when it is slid onto the cable.
................................................................................................................................
............................................
2 Sprinkle talcum powder on the inside and outside of the tapered (small)
end of the boot (because it will turn inside-out). Slide the boot onto the
antenna cable (tapered end towards antenna). Position the boot
approximately 8 inches from the end of the cable. Refer to the figure
below.
................................................................................................................................
............................................
3 Prepare the end of the cable for the DIN connector. Use the appropriate
stripping tool part number provided in Chapter 1. Refer to Tools, supplies,
and parts required (master list) on Page 1 - 31.