User's Manual

3-8
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Cable connections in the Modular Cell 4.0B cabinets
Connect a terminated end
of the GPS antenna jumper
cables to the Modular Cell
4.0B primary cabinet, if
applicable
Important! If the GPS antenna jumper cable has already been
connected at the Modular Cell primary cabinet, skip to Connect the
GPS antenna jumper cable to the GPS surge protector at the GPS
antenna cable on Page 3 - 11 to continue the installation.
If the GPS antenna jumper cable is terminated on both ends, use the
following procedure to connect it to the Modular Cell 4.0B primary
cabinet.
................................................................................................................................
............................................
1 Obtain a rubber boot and slit it as shown in the Step 2 figure on Page 3-
8
................................................................................................................................
............................................
2 Slip the boot over the antenna cable (tapered end towards antenna).
Position the boot approximately 8 inches from the end of the cable.
Refer to the figure below.
................................................................................................................................
............................................
3 Insert one end of the jumper cable through the applicable opening in the
antenna cable cover.
BOTTOM VIEW
Split Boot