User's Manual

Cable connections in the Modular Cell 4.0B cabinets
3- 11
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Connect the GPS antenna
jumper cable to the GPS
surge protector at the GPS
antenna cable
Use the following procedure to terminate and connect the GPS antenna
jumper cable to the GPS surge protector at the GPS antenna cable.
................................................................................................................................
............................................
1 Route the GPS antenna jumper cable from the Modular Cell 4.0B
primary cabinet to the GPS antenna connection. Refer to the figure
below.
Important! The figure above is an example only. For side views
of the various configurations, refer to Chapter 1, starting at
Modular Cell 4.0B cabinet side view 1 on Page 1 - 26.
................................................................................................................................
............................................
2 Connect the GPS antenna jumper cable to the GPS antenna cable at the
surge suppressor.
MODULAR CELL
CABINET
ANTENNA JUMPER
CABLE SUPPORT STRUCTURE
ICE BRIDGE
(IF REQUIRED)
#6AWG STRANDED INSULATED
GROUND WIRE TO MAIN GROUND BUS
MAIN GROUND BUS
2-INCH LIQUID-TIGHT STEEL
FLEXIBLE CONDUIT
2-INCH HUB/COUPLING
2-INCH LIQUID-TIGHT
CONNECTOR (ASSEMBLY)
STRAP
2-INCH RIGID STEEL CONDUIT
FOR AC POWER SUPPLY
(2) #2 AWG BARE
SOLID TINNED COPPER
WIRE TO GROUND ELECTROD
E
SYSTEM
FINISHED GRADE
MOUNTING BASE
(OPTIONAL)
CONCRETE PAD
SOUND MUFFLER
GPS ANTENNA
JUMPER CABLE
GPS ANTENNA
SURGE PROTECTOR