User's Manual

3-12
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Cable connections in the Modular Cell 4.0B cabinets
Important! When connecting/disconnecting a Lucent RF
coaxial jumper cable assembly to/from any 7-16 DIN female
receptacle connector, it is highly recommended that the cable
assembly be connected/disconnected as shown in the figure that
follows. Please note that the mating receptacle connector requires
a wrench for support. Wrenches for connecting/disconnecting the
mating RF coaxial jumper cable's 7-16 DIN male plug, which is
equipped with a rotating coupling nut, are required.
................................................................................................................................
............................................
3 Torque the antenna jumper cable connections at the antenna connection
to 221 in.-lb. (25 Nm) using the method shown in the figure below.