User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

Cable connections in the Modular Cell 4.0B cabinets

3- 13

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Connection of the conduit with T1/E1 lines and external user alarms

cables to a 4.0B primary cabinet

Important! If installing a Modular Cell 4.0B dual band cabinet

in a line up that has a 3.0, 4.0, or 4.0B primary cabinet with

integrated power, skip to How to route the T1/E1 cable(s) to a

Modular Cell 4.0B dual band cabinet in a line-up that has a Modular Cell

3.0, 4.0, or 4.0B primary cabinet with integrated power on Page 3 - 16

and continue the installation from that point.

If installing a Modular Cell 4.0B dual band cabinet in a line up

that has a 1.0, 2.0., 3.0 or 4.0 primary cabinet without integrated

power, skip to How to route the T1/E1 cable(s) to a Modular Cell 4.0B

dual band cabinet in a line-up that has a Modular Cell 1.0, 2.0, 3.0, 4.0,

or 4.0B primary cabinet without integrated power on Page 3 - 18 and

continue the installation from that point.

Connect the conduit

between the metal conduits

and the antenna cable

cover of the 4.0B primary

cabinet

Perform the following steps to connect the conduit (flexible or rigid,

depending upon local code), containing the T1/E1 and user alarm

cables, between the metal conduit and the antenna cable cover of the

4.0B primary cabinet. The metal conduit was installed as part of site

preparation.

Important! Before connecting the conduit at the 4.0B primary

cabinet, the T1/E1 and external user alarm cables most be pulled

through the unconnected conduit and into the antenna cable cover

................................................................................................................................

............................................

1 Locate the metal conduit for the T1/E1 and user alarm cables, and, if

installed, remove the end cap from the metal conduit.

................................................................................................................................

............................................

2 Remove the end panel from the antenna cable cover, and then remove

the 2-inch hole cover from the left panel on the rear of the cover.

................................................................................................................................

............................................

3 Pull the T1/E1 and user alarm cables out of the metal conduit.