User's Manual

Cable connections in the Modular Cell 4.0B cabinets
3- 15
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
9 Refer to the figure below for the completed installation.
Important! Proceed to
Routing of T1/E1 and user alarm cables into
a Modular Cell 4.0B cabinet on Page 3 - 27 to route the T1/E1 and
user alarm cables into the Modular Cell 4.0B primary cabinet.
Important! Refer to the figure on Page 3-11 for a profile view
of a cabinet with a sound muffler. For a profile view of a cabinet
with alternate cable routings, refer to Chapter 1, Modular Cell 4.0B
cabinet side view 2 on Page 1 - 27
MODULAR CELL
PRIMARY CABINET
2-INCH LIQUID-TIGHT
CONNECTOR (ASSEMBLY)
STRAP
ANTENNA JUMPER
CABLE SUPPORT STRUCTURE
ICE BRIDGE
(IF REQUIRED)
2-INCH RIGID STEEL
FOR TI/E1 & USER ALARMS
#6AWG STRANDED INSULATED
GROUND WIRE TO MAIN GROUND BUS
MAIN GROUND BUS
2-INCH LIQUID-TIGHT STEEL
FLEXIBLE CONDUIT
(2) #2 AWG BARE
SOLID TINNED COPPER
WIRE TO GROUND ELECTRODE
SYSTEM
FINISHED GRADE
MOUNTING BASE
(OPTIONAL)
CONCRETE PAD
REAR HEAT
EXCHANGER