User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

3-16

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Cable connections in the Modular Cell 4.0B cabinets

How to route the T1/E1 cable(s) to a Modular Cell 4.0B dual band

cabinet in a line-up that has a Modular Cell 3.0, 4.0, or 4.0B primary

cabinet with integrated power

Important! If installing a Modular Cell 4.0B dual band cabinet

in a line up that has a 1.0, 2.0, 3.0, 4.0 or 4.0B primary cabinet

without integrated power, skip to How to route the T1/E1 cable(s) to

a Modular Cell 4.0B dual band cabinet in a line-up that has a Modular

Cell 1.0, 2.0, 3.0, 4.0, or 4.0B primary cabinet without integrated power

on Page 3 - 18 and continue the installation from that point.

Important! This procedure module provides instructions for the

routing of the T1/E1 cable(s) to a Modular Cell 4.0B dual band

cabinet, that has been installed with a line-up that has an existing

3.0, 4.0, or 4.0B Modular Cell primary cabinet with integrated

power.

Route T1/E1 cables to the

Modular Cell 4.0B dual

band cabinet

Important! The number T1/E1 cables to be routed will vary

depending upon the Universal Radio Controller (URC or URCII)

in use in the 4.0B dual band cabinet being installed. A URC

accepts a maximum of twelve TI/E1 lines, and requires only one

cable. A URCII accepts a maximum of twenty TI/E1 lines, which

requires an additional cable.

Perform the following steps to route the T1/E1 cables to the Modular

Cell 4.0B dual band cabinet.

Important! If the existing primary cabinet has a 66ECv2

battery cabinet attached (which utilizes a vertical duct for cable

routing) do not route the T1/E1 cables through the vertical duct

unless the antenna cable cover conduit is not present

.....

......................................................................................................................................

1 Locate the T1/E1 cables and pull them through the existing conduit and

into the antenna cable cover of the primary cabinet. Refer to the figure

on Page 3-17.

................................................................................................................................

............................................

2 Using a #8 drilled spanner driver, remove the applicable rear panels

from the antenna cable covers of the Modular Cell cabinets. Refer to the

figure on Page 3-17.