User's Manual

Cable connections in the Modular Cell 4.0B cabinets
3- 17
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
3 If necessary, use a #14 drilled spanner driver to remove the top panels
from the antenna cable cover of the applicable cabinets.
................................................................................................................................
............................................
4 Route the T1/E1 through the antenna cable cover(s) to the location of the
feed-through cord grip seal in the 4.0B dual band cabinet being installed.
Refer to the figure on Page 3-29 and the figure below.
Important! Proceed to Routing of T1/E1 and user alarm cables into
a Modular Cell 4.0B cabinet on Page 3 - 27 to route and connect the
T1/E1 cables in a Modular Cell 4.0B dual band cabinet
PRIMARY CABINET
G-1 POSITION
G-2 POSITION
G-3 POSITION
REAR VIEW
REMOVE THESE REAR
PANELS, AS REQUIRED
REMOVE TOP
PANELS, AS
REQUIRED
NOT ALL OF THE LINE-UPS BELOW ARE EXISTING CONFIGURATIONS
PRIMARY G-1 G-2 G-3
4.0B 4.0B
4.0 4.0 4.0B
3.0 4.0 4.0B
3.0 3.0 4.0 4.0B