User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

3-18

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Cable connections in the Modular Cell 4.0B cabinets

How to route the T1/E1 cable(s) to a Modular Cell 4.0B dual band

cabinet in a line-up that has a Modular Cell 1.0, 2.0, 3.0, 4.0, or 4.0B

primary cabinet without integrated power

Important! If installing a Modular Cell 4.0B primary cabinet

only, skip to Routing of T1/E1 and user alarm cables into a Modular

Cell 4.0B cabinet on Page 3 - 27 and continue the installation from

that point.

Important! The number T1/E1 cables to be routed will vary

depending upon the Universal Radio Controller (URC or URCII)

in use in the 4.0B dual band cabinet being installed. A URC

accepts a maximum of twelve TI/E1 lines, and requires only one

cable. A URCII accepts a maximum of twenty TI/E1 lines, which

requires an additional cable.

This procedure module provides instructions for the routing of the T1/

E1 cable(s) to a Modular Cell 4.0B dual band cabinet, if it has been

installed in a line-up that has an existing 1.0, 2.0, 3.0, 4.0, or 4.0B

Modular Cell primary cabinet without integrated power. The

procedures vary depending upon the type of power source

Step-by-step instructions are provided for the following tasks.

Route the T1/E1 cable(s) to the Modular Cell 4.0B dual

band cabinet (in line-ups that utilize existing

PowerHouse24 or customer supplied power)

3 - 19

Route the T1/E1 cable(s) to the Modular Cell 4.0B dual

band cabinet (in installations that utilize an existing WNG

power cabinet)

3 - 24