User's Manual

3-24
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Cable connections in the Modular Cell 4.0B cabinets
Route the T1/E1 cable(s) to
the Modular Cell 4.0B dual
band cabinet (in
installations that utilize an
existing WNG power
cabinet)
Important! This procedure applies to WNG power cabinets
installed with 1.0/2.0 primary cabinets only. For WNG power
cabinets installed with 3.0 and 4.0 primary cabinets, use the
procedure Route T1/E1 cables to the Modular Cell 4.0B dual band
cabinet on Page 3 - 16
Perform the following steps to route the T1/E1 cable(s) to a 4.0B dual
band cabinet in a line-up that utilizes an existing WNG power cabinet
with a 1.0/2.0 primary cabinet. The 2-inch conduit was installed as part
of Modular Cell 1.0/2.0 cabinet installation with a WNG power
cabinet.
Important! If a 4.0B dual band cabinet is installed in a line-up
with existing 1.0, 2.0, 3.0, or 4.0 cabinets that utilize a WNG
power cabinet, the total load for all cabinets is limited to 17Kw.
The total number of carriers possible in the 4.0B dual band cabinet
may be limited. Use of a dual band cabinet with Integrated Power
is recommended to overcome this limitation
................................................................................................................................
............................................
1 Using a #14 drilled spanner driver, remove the top panel from the
antenna cable covers of the Modular Cell cabinets. Refer to the figure
below.
................................................................................................................................
............................................
2 Using a #8 drilled spanner driver, remove the rear panels from the
antenna cable covers of the Modular Cell cabinets, as required.
WNG POWER
CABINET
MODULAR CELL
1.0/2.0 PRIMARY
CABINET
REMOVE REAR
PANELS AS
REQUIRED
POWER CABINET
PRIMARY CABINET
G-1 POSITION
G-2 POSITION
REMOVE TOP
PANEL(S) AS
REQUIRED
G-3 POSITION