User's Manual

Cable connections in the Modular Cell 4.0B cabinets
3- 29
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Install the EMI / RFI cord
grip seals with T1/E1 and
user alarm cables
The T1/E1 or user alarm cables enter the cabinet through an EMI / RFI
cord grip seal. This seal grounds the cable shield to the cabinet.
Perform the following steps to install the EMI / RFI cord grip seals
with T1/E1 and/or user alarm cables as applicable
................................................................................................................................
............................................
1 Identify the correct cable entry point cord grip seals for the cable(s) at
the top of Modular Cell 4.0B cabinet, as shown in the figures below;
Type 1 with three feed throughs, and Type 2 with six feed throughs.
POWER ALARMS
OR
EXTERNAL DC
(OPTION)
USER ALARMS
T1/E1 CABLE
TYPE 1
T1/E1 CABLE
T1/E1 CABLE #1
T1/E1 CABLE #2
SPARE
USER ALARMS
POWER ALARMS
OR
EXTERNAL DC
(OPTION)
USER ALARMS
POWER ALARMS
OR
EXTERNAL DC
(OPTION)
TYPE 1
SPARE
TYPE 2