User's Manual

3-30
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Cable connections in the Modular Cell 4.0B cabinets
................................................................................................................................
............................................
2 The figure below shows the various parts of the cord grip seal. Note that
the cord grip seal should not be disassembled. Refer to the figure on
Page 3-31 for the completed installation
................................................................................................................................
............................................
3 From the front of the cabinet, loosen the thumb screws on the EFIT
(facilities interface tray), and open the tray. Refer to the figure on Page
3-36.
................................................................................................................................
............................................
4 Loosen the dome.
Important! When performing the next two steps, it is necessary
to have a second person help by pulling the cable through the
facilities interface panel from the front of the cabinet.
................................................................................................................................
............................................
5 Insert the end of the cable into the top of the cord grip seal assembly (on
the top of the cabinet).
................................................................................................................................
............................................
6 Slowly push the cable through the cord grip seal assembly until the cable
is fully into the cabinet.