User's Manual

Cable connections in the Modular Cell 4.0B cabinets
3- 31
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Important! The figure below is not drawn to scale.
................................................................................................................................
............................................
7 Pull the cable back a few inches, and strip the outer insulation from the
cable to expose approximately 38 mm (1.5 inch) of the shield as shown
in the figure below. Do not cut the shield.cable
Important! When performing the next step, take care not to
insert the cable insulation (above the stripped area) more than
3/8-inch into the rubber strain relief insert.
Important! The figure below is not drawn to scale.
................................................................................................................................
............................................
8 Insert the cable back into the seal as shown in the figure below.
................................................................................................................................
............................................
9 Tighten the dome.