User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 59
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
b. Place two expansion stud assemblies, or threaded rods, in the
back mounting holes, without the large washer on each
assembly.
c. Do not torque the nuts at this time.
Important! When performing the next step, if the cabinet door
does not align properly when closed, the cabinet may be releveled
until correct door alignment is achieved, or the door may be
adjusted, as applicable. Refer to Door adjustment procedure on Page
2 - 76 for the adjustment procedure. Since it may be necessary to
re-level the previous cabinet when connecting a dual band cabinet,
you may wish to delay adjustment of the door(s) until all cabinets
have been placed, leveled, and anchored.
................................................................................................................................
............................................
E ND OF STEPS
................................................................................................................................
.............................................
2 Verify that the cabinet door aligns properly when closed.
PLATE WASHER
(REMOVED FOR
REAR MOUNTING
HOLES ONLY)
SPREADER
NUT
FLAT
WASHE R
THREADED
ROD
NUT
REMOVABLE
SPACER