User's Manual

5-86
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Component installation in the Modular Cell 4.0B and the
WNG24-BC battery cabinets
................................................................................................................................
............................................
1 Loosen the screw and open the HPDA door. Refer to the figure below.
Important! If installing a second battery cabinet only, skip to
Connect the DC return cables from the battery cabinet to the return bus
in the primary cabinet on Page 5 - 87 to continue the installation.
................................................................................................................................
............................................
2 Remove the knockout shown in the figure above.
................................................................................................................................
............................................
3 Remove the tape or shrink tubing from the end of one of the four red
+24-VDC cables.
................................................................................................................................
............................................
4 Connect this +24-VDC cable (from the first battery cabinet) in the
Modular Cell 4.0B primary cabinet. Refer to the figure below.
REMOVE KNOCKOUT