User's Manual

5-90
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Component installation in the Modular Cell 4.0B and the
WNG24-BC battery cabinets
................................................................................................................................
............................................
6 At the first battery cabinet, make all of the battery cable connections on
the front of the battery retaining brackets. Refer to the figure below, item
2.
Important! If installing the first battery cabinet only, skip the
next step.
................................................................................................................................
............................................
7 At the second battery cabinet, make all of the battery cable connections
on the front of the battery retaining brackets. Refer to the figure below,
item 2.
................................................................................................................................
............................................
8 If applicable, place all unused battery cable assemblies in a plastic bag
on an unpopulated battery shelf.
TO BUS BAR
FROM BATTER
Y
FRONT VIEW
CHECK CORRECT POLARITY
OF BATTERY CABLE
CONNECTIONS BY
MEASURING VOLTAGE HERE
BATTERY
RETAINING
BRACKET
(1 of 5)
SHELF 1
SHELF 2
MAKE ALL 10 BATTERY CABLE CONNECTIONS ON
THE BATTERY RETAINING BRACKETS IN BOTH
BATTERY CABINETS, AS APPLICABLE
1
2