User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

6-8

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

RF cable connections between existing Modular Cell

cabinets and a 4.0B dual band cabinet

Routing and connection of RF inter-frame cables to a 4.0B Modular

Cell dual band cabinet

Overview

This module covers the following procedures required to route and

connect the inter-frame cables from the Modular Cell 4.0B dual band

cabinet being installed to the existing Modular Cell 4.0B, 4.0, 3.0, 2.0,

or 1.0 primary, or G-2 4.0 growth cabinet, as applicable. A line-up table

is provided at the end (for reference only).

Before you begin

Before proceeding with these instructions, refer to Determine the

prerequisite changes needed in the existing cabinet(s) in your line-up

configurationon Page 6 - 5 to assure that all prerequisites for the

connection of inter-frame cables have been met.

Route and connect the 15-MHz cable(s) 6 - 9

Route and connect the GPS cable 6 - 18

Line-up table 6 - 26