User's Manual

RF cable connections between existing Modular Cell
cabinets and a 4.0B dual band cabinet
6- 11
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
..............................................
6 Remove the bolts from the front of the shelf, on which the Smart Switch
is located, and carefully pull out the shelf. Refer to the figure below.
................................................................................................................................
..............................................
7 Route the cable onto the shelf and connect the 15-MHz cable(s), and set
the Smart Switch dip switches as shown for line-up 4 in the table starting
on Page. 6 - 12. Refer to the figure on Page 6-14.
................................................................................................................................
..............................................
8 Slide the shelf back into the cabinet and replace the bolts. If the air baffle
was mounted on the door., replace the air baffle above the radio shelves.
Important! If the primary cabinet is a 3.0, skip the next step.
................................................................................................................................
..............................................
9 For line-ups 1 through 3, and 5 and 6, connect the 15-MHz cable(s), as
shown for the applicable line-up in the table starting on Page. 6 - 12.
................................................................................................................................
..............................................
10 Coil the unused portion of the 15-MHz cable in the Modular Cell 4.0B
dual band cabinet being installed.
................................................................................................................................
..............................................
11 Using wire ties, secure the cables in all cabinets in such a way that they
do not interfere with removal / replacement of components, and front
door closure.