User's Manual

5-74
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Component installation in the Modular Cell 4.0B and the
WNG24-BC battery cabinets
Connect the positive
battery cables to the
batteries
Important! When performing the following steps, for safety
reasons, always connect the positive battery cables first and the
negative battery cables last (when instructed to do so).
Perform the following steps to connect the positive battery cables to the
batteries.
................................................................................................................................
............................................
1 Locate the ten separately shipped battery cable assemblies.
................................................................................................................................
............................................
2 Separate two of the battery cables. The positive cables from each of the
two battery cables will be connected to the batteries in the next step.
Important! When performing the next step, note that the two
positive battery cables being connected come from two separate
battery connectors. Refer to the figure on Page 5-75.
................................................................................................................................
............................................
3 Apply antioxidant compound to the two positive (+) terminals of
batteries 5 and 6. Refer to the figure on Page 5-75.
................................................................................................................................
............................................
4 Connect the two positive (+) battery cables (from separate connectors)
to the positive (+) terminals of batteries 5 and 6, using the flat washers,
lock washers and nuts.