User's Manual

RF cable connections between existing Modular Cell
cabinets and a 4.0B dual band cabinet
6- 19
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
..............................................
6 Route the cable above the filters in the primary cabinet as shown for the
applicable line-up in the table starting on Page. 6 - 20.
................................................................................................................................
..............................................
7 Wire-tie the cable in place above the filters.
................................................................................................................................
..............................................
8 In the primary cabinet, at the splitter, remove the terminator from:
• Port 6 on the 1:5 splitter if installing a 4.0B dual band cabinet in
the G-2 position
• Port 5 on the 1:5 splitter if installing a 4.0B dual band cabinet in
the G-3 position
................................................................................................................................
..............................................
9 Connect the GPS cable to the GPS splitter in the primary cabinet as
follows and as shown for the applicable line-up in the table starting on
Page 6 - 20.
• If installing a 4.0B dual band cabinet in the G-2 position, connect
the GPS cable to port 6 on the 1:5 splitter
• If installing a 4.0B dual band cabinet in the G-3 position, connect
the GPS cable to port 5 on the 1:5 splitter
................................................................................................................................
..............................................
10 Inside the 4.0B dual band cabinet being installed, coil and tie the slack
portion of the GPS cable not routed to the primary cabinet.
................................................................................................................................
..............................................
11 Using wire ties, secure the GPS cable in place in all cabinets in such a
way that it does not interfere with removal / replacement of components,
and front door closure.