User's Manual
![](/manual/alcatel-lucent-usa/onebts-11/5-4-3-2-1-user-s-manual-english/images/img-4.png)
Component installation in the Modular Cell 4.0B and the
WNG24-BC battery cabinets
5- 75
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
5 Repeat Steps 2 through 4 for all remaining battery shelves, if applicable.
Remember, for safety reasons, to connect the positive battery cables first
and the negative battery cables last (when instructed to do so).
................................................................................................................................
............................................
6 Do not torque the nuts on the positive battery connections at this time.
The nuts on all positive battery connections will be torqued after
E ND OF STEPS
................................................................................................................................
.............................................
mounting of the series bus bars in the next procedure.
S-1
S-2
1
2
3
4
5
6
1
2
3
4
5
6
-
+
-
+
BATTERY CABLE
ASSEMBLY
(2 of 10)