User's Manual

Finishing the installation
7- 3
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
.............................................................................................................................................................................................................................................................
Check of antenna connection status
Verify GPS antenna
connection
Verify that the GPS antenna is properly connected, as outlined in
Chapter 3 of this document. Verify that it meets all of the appropriate
guidelines in accordance with the following documents.
Flexent

Modular Cell 4.0/4.0B Outdoor Site Preparation Guidelines,
document number 401-703-413
• Grounding and Lightning Protection Guidelines for Lucent
Technologies Network Wireless System Cell Sites, document
number 401-200-115
Important! The GPS antenna must be connected to the Modular
Cell 4.0B primary cabinet prior to " Initial start up and system
test". Refer to Chapter 3. Do not connect RF antenna jumper
cables.
Verify RF antennas not
connected
The RF antennas must not be connected to the primary or dual band
cabinets until power-up and system test has been performed.