User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

7-4

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Finishing the installation

Power-up and system test

Perform power-up and

system test

Following installation of the Modular Cell 4.0B primary or dual band

cabinets, the system should be tested before being put into operation.

System test and integration procedures are not covered in this

installation document. This information is contained in Lucent

Technologies Installation Engineering Handbook 238. Consult the

specific reference below. Power-up and system test can be performed if

the following tasks are completed.

• All cabinets are installed as specified in this document.

• The GPS antenna cable is connected.

• RF antenna jumper cables are not connected to the Modular Cell

4.0B primary or 4.0B dual band cabinets.

Important! Refer to Lucent Technologies Installation

Engineering Handbook 238 for procedures for power-up and

stand-alone testing. Section 221 is for power-up.