User's Manual

Finishing the installation
7- 9
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
................................................................................................................................
............................................
3 Sprinkle talcum powder on the inside and outside of the tapered (small)
end of the boot (because it will turn inside-out). Slide the boot onto the
antenna cable (tapered end towards antenna). Position the boot
approximately 8 inches from the end of the cable. Refer to the figure
below.
................................................................................................................................
............................................
4 Prepare the end of the cable for the DIN connector. Use the appropriate
stripping tool part number provided in Chapter 1. Refer toTools, supplies,
and parts required (master list) on Page 1 - 31.
................................................................................................................................
............................................
5 Terminate the end of the cable with the male DIN connector provided.
................................................................................................................................
............................................
6 Insert the connector end of the jumper cables through the applicable
openings in the antenna cable cover.