User's Manual

7-10
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Finishing the installation
................................................................................................................................
............................................
7 Connect the RF antenna jumper cable to the applicable connector on the
Modular Cell 4.0B primary or 4.0B dual band cabinet. Refer to the
figure below.
................................................................................................................................
............................................
8 Slowly slide the boot towards the cabinet and install it into the opening
on the antenna cover. Refer to the figure below.
................................................................................................................................
............................................
9 Pull the boot back towards you to ensure that the lip of the boot is fully
seated.
................................................................................................................................
............................................
10 Repeat Steps 2 through 9 for all antenna jumper cables.
GPS
S3D1
S1D1
S2D1
S3D0
S2D0
S1D0