User's Manual

Finishing the installation
7- 11
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Important! When connecting / disconnecting a Lucent RF
coaxial jumper cable assembly to/from any fixed panel mounted
7-16 DIN female receptacle, it is highly recommended that the
cable assembly be connected/disconnected as shown in the figure
below. Please note that the mating receptacle is not shown because
it is a fixed and secured interface. Wrenches for connecting/
disconnecting the mating RF coaxial jumper cable's 7-16 DIN
male plug, which is equipped with a rotating coupling nut, are
required.
................................................................................................................................
............................................
11 Torque the antenna jumper cable connections at the applicable Modular
Cell cabinet to 221 in.-lb. (25 Nm) using the method shown in the figure
below.
................................................................................................................................
............................................
12 Replace the top panel on the antenna cable cover. Torque the tamper-
proof screws to 15-20 in.-lb. (1.7 - 2.3 Nm).