User's Manual

7-12
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
...........................................................................................................................................................................................................................................................
Finishing the installation
Connect a terminated end
of the outdoor RF antenna
jumper cables to the
Modular Cell 4.0B primary
or 4.0B dual band cabinet
Important! If the antenna jumper cables have already been
connected at the Modular Cell primary or dual band cabinet, skip
to Connect RF antenna jumper cables to the antenna cables on Page 7
- 15 to continue the installation.
The Modular Cell 4.0B primary or 4.0B dual band cabinet require six
RF antenna jumper cables. These jumper cables may be terminated on
both ends with 7/16-inch straight DIN connectors. One end will be
attached to the RF connectors on the Modular Cell cabinet, which is
reached through the entry openings on the antenna cable cover of the
cabinet. The other end will connect directly to the surge suppressors on
each RF antenna at the outdoor cable rack support. Refer to the figure
on Page 7-15.
Use the following procedure to connect the RF antenna jumper cables
to the Modular Cell 4.0B primary or 4.0B dual band cabinet.
................................................................................................................................
............................................
1 Label both ends of each RF antenna jumper cable: S1D0, S1D1, S2D0,
S2D1, S3D0, S3D1.
................................................................................................................................
............................................
2 Obtain a rubber boot and split it as shown in the figure below.
................................................................................................................................
............................................
3 Slip the boot over the antenna cable (tapered end towards antenna).
Position the boot approximately 8 to 10 inches from the end of the cable.
Refer to the figure below.
BOTTOM VIEW
Split Boot