User's Manual

Overview of the Flexent‚ Modular Cell 4.0B cabinet
installation
1- 33
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
• Silicone caulk
• Socket sets (decimal and metric) various drives
• Stripping tool (for LDF4 antenna jumper cables) part number 74Z-
0-12-15
• Talcum powder
• Tools for preparing cables
• Torque wrenches, 35 - 300 in.-lb. (4 - 34 Nm)
• Torque wrenches, 4.4 -150 ft.-lb. (6 - 200 Nm)
• Thread sealing tape
• Vacuum cleaner or equivalent, as required for clearing debris from
anchor holes
• Volt/ohmmeter
• Wire cutter/stripper
• Wire rope slings, 7/16-inch (11 mm), 7 feet long (2 m), minimum
(quantity: 2)
• Wrench - adjustable, (3/4 in./20 mm) open-ended wrench (or set
of fixed open-ended wrenches)
The following supplies are required.
• 1-inch and 2-inch flexible conduit and connecting hardware
• Antioxidant compound (provided)
• Cable - #2-AWG (35-mm2) grounding wire for cabinet grounds
(provided as part of site preparation)
• Foam gasket tape
• Shims - for leveling and final placement of cabinet (some are
provided with anchoring kit)
• Tags or labels - for marking cables
• Talcum powder (or equivalent, for fitting the cable boots over the
antenna jumper cables)
• Tape - electrical
• Tape/marker or equivalent for labeling cable
• Tie wraps and/or twine
• Two #2-AWG double-hole terminal lugs with connecting
hardware for cabinet grounds (supplied with cabinet)
User alarm cable (supplied as part of site preparation