User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

Modular Cell 4.0B and WNG24-BC cabinet handling,

placement, anchoring and grounding

2- 5

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Anchor installation

Mark and drill the anchor

holes

Important! Note that outdoor cabinets may be mounted directly

on a concrete or on optional steel mounting bases. EZBFo battery

frames may be mounted directly on a concrete pad. Procedures for

the preparation of other types of mounting surfaces are the

responsibility of the customer.

If not already accomplished during site preparation, use the following

procedure to mark and drill the anchor holes in a concrete surface.

.....

......................................................................................................................................

1 Mark the surface for all cabinets to be installed (using the information

provided in the document listed below) for cabinet anchoring

dimensions, or steel mounting base anchoring dimensions.

• Flexent



Modular Cell 4.0/4.0B Site Preparation

Guidelines, 401-703-413.

................................................................................................................................

............................................

2 If installing a EZBFo battery base module, consult the above document

and skip to Appendix A to continue the installation.

................................................................................................................................

............................................

3 Drill the anchor holes to the proper size and depth as specified in the

previous table. Refer to the figure on Page 2-6 for the anchor hole

drilling method.

Important! If a 4-inch hole depth cannot be attained for a 12-

mm expansion stud anchor (seismic zones 3 and 4), a spacer may

be removed from the anchor assembly, prior to the anchor being

set. In this case, 1 inch must be cut from the end of the threaded

rod, prior to the anchor being set. Refer to the instructions

provided with the anchor setting procedure.

................................................................................................................................

............................................

4 Vacuum out the holes. Refer to the figure on Page 2-6.