User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

Modular Cell 4.0B and WNG24-BC cabinet handling,

placement, anchoring and grounding

2- 11

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

Installation of optional steel mounting bases for a 4.0B primary

cabinet with integrated power, and battery cabinets if applicable

Overview

Important: If installing a dual band cabinet on a mounting base, skip to

Installation of optional steel mounting bases for a 4.0B dual band cabinets on

Page 2 - 16 to continue the installation.

This section provides procedures for the installation of optional steel

mounting bases, for primary and battery cabinets, at various seismic

zone sites.

This section covers the following procedures.

Install the optional bases

for the primary cabinet, and

battery cabinets if

applicable, using zone 0, 1,

and 2 type anchors

Important! If using zone 3 or 4 anchors, skip to Install the

optional mounting bases for the primary cabinet, and battery cabinets if

applicable, using zone 3 and 4 type anchors on Page 2 - 13 and

continue the installation from that point.

Important! If installing a mounting base for the first battery

cabinet only, perform only the Step 4 instructions. If installing a

mounting base for the second battery cabinet only, perform only

the Step 5 and Step 6 instructions.

Perform the following steps to install mounting bases using zone 0, 1,

and 2 type anchors.

................................................................................................................................

............................................

1 Align the Modular Cell 4.0B cabinet mounting base mounting holes

with the anchor holes.

................................................................................................................................

............................................

2 Place the two washers onto each anchor bolt, and insert the anchoring

bolts through the mounting base holes and into the anchors. Refer to the

figure on Page 2-12. Level the mounting base (as required) using shims.

Install the optional bases for the primary cabinet, and

battery cabinets if applicable, using zone 0, 1, and 2

type anchors

2 - 11

Install the optional mounting bases for the primary

cabinet, and battery cabinets if applicable, using zone 3

and 4 type anchors

2 - 13