User's Manual

Modular Cell 4.0B and WNG24-BC cabinet handling,
placement, anchoring and grounding
2- 17
Lucent Technologies – Proprietary
See notice on first page
401-703-454
FOA Draft Issue 1
January, 2006
............................................................................................................................................................................................................................................................
Install the optional
mounting bases for a dual
band cabinet, using zone 0,
1, and 2 type anchors
Important! If using zone 3 or 4 anchors, skip to Install the
optional mounting bases for a dual band cabinet using zone 3 and 4
type anchors on Page 2 - 19 and continue the installation from that
point.
Perform the following steps to install the dual band cabinet mounting
base using zone 0, 1, and 2 type anchors.
................................................................................................................................
............................................
1 Align the cabinet mounting base mounting holes with the anchor holes.
................................................................................................................................
............................................
2 Place the two washers onto each anchor bolt, and insert the anchoring
bolts through the mounting base holes and into the anchors. Refer to the
figure on Page 2-18.
................................................................................................................................
............................................
3 Level the mounting base (as required) using shims.
................................................................................................................................
............................................
4 Start threading the anchoring bolts, but leave them loose (they will be
tightened later).
................................................................................................................................
............................................
5 Attach the dual band cabinet mounting base to the previous Modular
Cell mounting base using the four bolts, flat washers and lock washers
supplied. Refer to the figure on Page 2-18.