User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

Modular Cell 4.0B and WNG24-BC cabinet handling,

placement, anchoring and grounding

2- 33

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

............................................................................................................................................................................................................................................................

a. Place two expansion stud assemblies, or threaded rods, into

the front mounting holes using both washers on each

assembly. Refer to the figure below.

b. Place two expansion stud assemblies, or threaded rods, in the

back mounting holes, without the large washer on each

assembly.

c. Do not torque the nuts at this time if a 4.0B dual band cabinet

remains to be installed. If not, level the cabinet using the

supplied shims, and torque to 58 ft-lb (79 Nm).

................................................................................................................................

............................................

2 Verify that the cabinet door aligns properly when closed.

Important! If the cabinet door does not align properly when

closed, the cabinet may be releveled until correct door alignment

is achieved, or the door may be adjusted, as applicable. Refer to

Door adjustment procedure on Page 2 - 76 for the adjustment

procedure. Since it may be necessary to re-level the primary

cabinet when connecting a battery or dual band cabinet, you may

wish to delay adjustment of the door(s) until all cabinets have

been placed, leveled, and anchored.

................................................................................................................................

............................................

3 If no further cabinets remain to be installed, proceed to Install the cabinet

grounding cables on Page 2-65 to continue the installation.

PLATE WASHER

(REMOVED FOR

REAR MOUNTING

HOLES ONLY)

SPREADER

NUT

FLAT

WASHER

THREADED

ROD

NUT

REMOVABLE

SPACER