User's Manual

ManualsBrandsAlcatel-Lucent USA ManualsElectronicsUMTS-CDMA Transceiver System (850)

2-34

Lucent Technologies – Proprietary

See notice on first page

401-703-454

FOA Draft Issue 1

January, 2006

...........................................................................................................................................................................................................................................................

Modular Cell 4.0B and WNG24-BC cabinet handling,

placement, anchoring and grounding

Placement and anchoring of the WNG24-BC battery cabinets

Overview

This procedure module provides the following instructions.

For the purpose of these instructions, the WNG24-BC battery cabinet

will be hereafter referred to as the first or second battery cabinet, or the

existing cabinet wen required.

• Placement, anchoring and grounding the WNG24-BC battery

cabinet, both first and second.

• Physical connection of a WNG24-BC battery cabinet to the

primary Modular Cell 4.0B or a second WNG24-BC battery

cabinet to the first battery cabinet (since the instructions are the

same, references will be to attaching a battery cabinet to the

existing cabinet)

This module contains the following procedures.

Prepare the existing cabinet for attachment of an additional

cabinet

2 - 35

Prepare the cabinet being installed for attachment to the

existing cabinet

2 - 37

Partially install the AC cable guide in the cabinet being installed 2 - 39

Move/lift the cabinet being installed into position 2 - 40

Attach the cabinets together at the square cable support (with

second battery cabinet only)

2 - 42

Install anchoring bolts or anchor assemblies and level the

battery cabinet(s)

2 - 45

Complete the installation of the AC feed-through coupling and

tighten the anchor bolts or nuts

2 - 48